Press drawing parts maintenance and maintenance

HONESTY IS THE ROOT
Quality is always satisfactory
Hotline
+86 15231667166
LOCATION:Home > NEWS > Corporate dynamics >
NEWS CATEGORY
HOT PRODUCT
MORE
  • Jumper Jumper

    Jumper wire is stamping parts, hardware stamping parts hardness testing using rockwell hardness teste...

  • Chandelier housing Chandelier housing

    The shell of pendant lamp is a stamping part. The stamping part is a method of forming and processing...

  • Stainless steel instrument hoop Stainless steel instrument hoop

    Stainless steel instrument hoop is stamping piece, stamping piece is by the press and die on the plat...

  • Stainless steel stamping parts Stainless steel stamping parts

    Stainless steel stamping parts are made of stainless steel material processing products, stainless st...

  • LED screen frame LED screen frame

    The frame of LED screen is a stamping part. The stamping part is a method of forming and processing p...

Press drawing parts maintenance and maintenance

Jul 24

2019

NEWS DETAIL

In the production process, the direct change of raw material (or blank) shape, size and performance, make it into a finished product process, known as the process. It is a major part of the production process. Such as blank casting, forging and welding; Heat treatment to change material properties; Parts of the mechanical processing, etc., are technological processes. A process consists of one or more sequential processes.

1. Before the installation and use of the drawing parts, please check carefully to clear the dirt and eliminate the bad factors, and check carefully whether the guide sleeve of the drawing parts and the lubrication degree of the mold are normal or not.

2, partition time on the rotary table of the press and mold installation base carefully check, ensure the up and down of the coaxiality of the rotary table.

3. Install the concave and convex molds on the rotary table in strict accordance with the installation procedure of the molds. Make sure that their pulling parts are in the same direction.

4, once found that the convex and concave die edge of tensile parts wear, stop using, and timely change the edge, the old edge for grinding, will rapidly expand the serious impact on the wear of the mold, thus reducing product quality and shorten the life of the mold.

5. Later, we would like to remind everyone about our working attitude. We should be careful and patient.


SITE NAVIGATION
PAY ATTENTION TO US
CONTACT

HOT-LINE:+86 15231667166

Email: xinjiangmetalproducts@gmail.com

ADD : Fengjiakou town boguyu village, Nanpi County, Cangzhou City, Hebei Province (west side of national highway 104)

Copyright © 2019-2020 www.yshmetal.com. All Rights Reserved